3D Lizard Paper-Craft

“Creature Craft”

Hey Fellas! Welcome back again!! šŸ™‚

Here, I’ve got a new craft work for you all. In this tutorial i will be illustrating a 3D Lizard making . It’s a Cool 3D Lizard paper craft. You can place it on your table and have fun making an environment for your lizard by adding stones and moss around it. Make the lizard in different sizes to make a whole family. šŸ˜‰ šŸ™‚

Here’s the list what you’ll need to make one:

ā™¦ White and Orange pastel Sheet for the Lizard’s body.

ā™¦ Scraps of White and other colors for the details.

ā™¦ Glue

ā™¦ Scissor/ Craft Knife

ā™¦ Designer Scissor (for making the Zig-Zag Pattern teeths or you can make it free hand with the help of a casual scissor)

Let’s Start Making:

Step 1: Cut the shape of the lizard as the template shown below with scissor or craft knife.

3D Lizard Making Step-1

Step 2: Make a line with a pencil that runs down the middle of the lizard all the way from the tip of its nose/ head to its tail. Once your lizard has been made turn the craft knife (not the sharp side) or better use a scissor and crease along the line, also crease across the head and its legs. Do not put excessive pressure otherwise it will cut off. So BE CAREFUL!

3D Lizard Making Step-2

Step 3: Lightly press the sides of the Lizard and bend it. Start from the one end and work your way to the other. After bending your half part of the lizard, it’s all set to embellish.

3D Lizard Making Step-3

Here is how it will look after completing the bending session. šŸ˜‰

3D Lizard Making Step-3a

Step 4: Cut 2 large circles and 2 small circles to make the eyes. And glue them so.

3D Lizard Making Step-4

Step 5: Also cut 2 Larger Circles for the more bigger and catchy eyes and shape them in a zig-zag pattern.

3D Lizard Making Step-5

Step 6: Paste them together on lizard’s head, like below :

3D Lizard Making Step-6

Step 7: Now cut different sized circles to embellish the body and glue them randomly.

3D Lizard Making Step-7

Step 8: Cut an another zig-zag shape for teeth like this and paste it underneath the lizard’s head. Make sure that the pointy part peeps out the head.

3D Lizard Making Step-8

Step 9: To form a tongue, cut a small rectangle and snip it out from the end and paste it underneath the teeth.

3D Lizard Making Step-9

Check out this Final Outcome!! šŸ™‚

3D Lizard Making Step- Final

I have made two 3D Lizards, one with the tongue and another without tongue. šŸ˜‰ šŸ™‚

3D Lizard paper craft (A)

“3D Lizard”

3D Lizard paper craft (B)

Like it! Make it! Share it! šŸ™‚ šŸ˜‰

2 Comments

  1. by Nikhil Aggarwal on September 11, 2013  6:40 am Reply

    Gggaaazzzaabb,.,.,.,.,.., (y) :)

Leave a reply

Your email address will not be published.